v1.3 [Jan 13, 2017]
- Reports eye margin measurements.
- Cleaned up some formatting on the report.
- VBUS max is now 5.5V.
- Supports Rohde and Schwarz binary files. The Rohde and Schwarz oscilloscopes create two files for binary results, a .bin file and a .Wfm.bin file. For analysis select the .Wfm.bin file.
- Now ignores non monotonic transitions for jitter measurements.
- Added margins above and below eye – information only.
- Made no inrush event found a fail.
- Now correctly reports hub EOP width pass/waiver/fail.
- Now supports .wfm (Tek) and .bin (Agilent) binary formats.
- Fixed problem where the EOP was not measured properly.
- Will now analyze waveforms with missing sync bits.
- Fixed problem where it was not reporting low sample rate.
- Fixed non-monotonic edge measurement to find correct packet when multiple packets exist in the waveform.
- Fixed error when detecting SOF EOP.
Enables your computer to interface with your PICtail Daughter Board device.